Using And Decorating With Picture Rail
Of course, once you have pictures or other with appropriate picture wire or cords, rearranging and swapping out artwork should be as easy as unclipping or unhooking the suspension system from one item and refastening to hardware on the new item. Because artwork should be hung at eye level, you shouldnt have to climb a ladder to accomplish these rearrangements.
A few other decorative points youll want to consider with your picture rail include:
- Painting picture rail moulding to match your crown moulding and other trim will help it blend in. This matching technique is traditional and gives the most sophisticated look.
- You can also paint picture rail moulding to match your walls. Especially in more modern homes that may not have ornate crown moulding, matching any trim to your wall color will lend a sleeker overall look that puts focus on the artwork displayed.
- Just because you install picture rail, it does not mean you must use it. In newer homes constructed with drywall, picture rail isnt necessary to preserve the structural integrity of your walls. Dont feel guilty if you just like the look and dont plan to use it for its functional purpose!
You Bought The Art Now What Tips For Hanging Art In Your Home
Do you have art that’s just sitting around, or, worse, stuffed in a closet because you’re not sure where to put it or how to hang it?
I’ve said it before, and I’ll say it again: I believe that art was meant to be shared with others. So grab your art, read my tips below, and let’s get going!
While I firmly believe there is no right way or wrong way to decorate your home, I do think there a lot of right ways to hang and display art.
I spent all four years of college assisting in my school’s art gallery. I had an internship at a custom framing shop. As an adult, I have lived in eight different apartments/ homes. The best way to make a new place start to feel like home is to hang your art on the walls! And I’ve had a lot of experience doing it .
Here are my favorite tips I have learned over the years and rounded up from some of my favorite home decor blogs on how to correctly hang wall art in your home!
FIRST, my personal favorite, most important tip:
Do not hang your art too high! I repeat: do. not. hang. your. art. too. high.
You may be asking, “but, Jen, is there a correct height to hang art?”
Yes, yes there is. And the number one problem I’ve seen over and over is that people hang their art too high!
In the photo below, these 2 pieces are acting as one large piece of art, with the small gap between them hitting at 60″.
Q: How do I measure how high to hang my art on my wall?
You will need a tape measure, a pencil, and your artwork that is ready for hanging.
How Do You Attach Molding
Install the Moulding Locate and lightly mark the wall studs. Measure the distance between two inside corners and cut a piece of moulding to fit between the corners. Continue installing pieces until all the moulding is up. After all the moulding is up, touch up any raw edges with a light coat of finish.
Read Also: How To Fix Mold On Ceiling
Do They Still Make Picture Rail
This type of molding was once an elegant way of hanging artwork on hard-to-penetrate plaster walls. Popular in New England and Southern townhouses during the Victorian era, picture rails may seem like a quaint throwback, but they can still look fresh today and serve a purpose.
What is the formula for hanging pictures? When hanging something at an average eye level, position its center 57 to 60 inches from the floor. Use the following formula: Divide the height of the frame by two from that number, subtract the distance from the top of the frame to the hanging hardware add this number to 57, 58, 59, or 60.
How do you hang pictures on drywall without studs?
How do you hang a picture with a wall flush? How to Hang Pictures Flush Against the Wall
Good Questions: What Level To Hang Pictures
Im trying to hang pictures on my wall. My ceilings are 10 feet 6 inches. I have 14 inches of ceiling moldings and wall, then 4 inches of crown molding, then its 100 inches to the baseboard and 8 inches of baseboard. I have panel moldings at 10 inches below the crown molding and 10 inches up from the top of the baseboard. At what level should I hang the pictures? I heard someone say 54 inches, but from what? From both floor and ceiling, it looks really low. Is there a rule about where they should hang within the panel moldings? thanks, Alex
Our rule of thumb is to hang all pictures at 57 on center. This is gallery height and roughly the average human eye level.
To do this you measure up 57 from the floor . You want your pictures center whatever size over this point, so measure your picture top to bottom, divide it in half,
subtract whatever distance there is between wire and top of frame and then add that number to your 57. That is where you put the pin in.
As far as panel mouldings go, we would just use these to center pictures left to right. As far as 57 on center looking low, everyone hangs their pictures too high, so it seems odd at first. Dont worry, its correct. MGR
You May Like: Remove Mold From Ceiling In Bathroom
Caulk Fill The Nail Holes And Paint
See? Totally not hard at all. Especially when your part of the job is to watch, eat sandwiches and take pictures. Thanks Dad!
Anyone else like to add projects to your to-do list when it already looks ridiculously long? Ever tried to DIY crown molding?P.S.: If you like this, make sure you check out all our construction projects here, like how we made our DIY built-in bookshelf wall:
Install The Molding On The Corner
- Hold the molding pieces in position at the outside corner and check for a tight fit .
- Before nailing the molding to the wall, bore two pilot holes through the point of the miter joint. A 4d finish nail chucked into your drill works well here.
- Then apply glue to the miter joint and fasten each piece of crown with 6d or 8d finish nails top and bottom.
- At the corner joint, tap 4d finish nails through the pilot holes.
- Set all the nails.
Also Check: How To Clean Mold In Basements
Installing In New Houses
While its typically found in old houses with plaster walls, it can be a fun way to dress up plain drywall and give it a fancy old-world feel for very little money. If you plan to install new picture rail, whether you have a new house or old house, make sure you install it with strong nails. I recommend installing by nailing to every stud with a 2 1/2 15 ga. nail if you plan to hang anything of significance. 18 ga. brad nails, no matter how long, just wont have the holding power you need for this hard working molding.
How Do You Update A Picture Frame Molding
Here are five ways to upgrade your picture frame molding. Beneath the chair rail only. Above and beneath the chair rail. Add color inside the picture frame molding. Add texture inside the picture frame. Two layered molding. 10 of the Coolest Smart Home Features in the World. 10 Benefits from Using Laminate Wood Flooring.
Don’t Miss: How To Prevent Mold On Bathroom Ceiling
Exclusive Items From Our Brands
Find answers in product info, Q& As, reviews
Your question might be answered by sellers, manufacturers, or customers who bought this product.
Please make sure that you are posting in the form of a question.
Please enter a question.
|5.0 out of 5 stars||4.4 out of 5 stars||4.6 out of 5 stars||4.2 out of 5 stars||4.7 out of 5 stars||4.7 out of 5 stars|
Well crafted brass plated steel molding picture frame hooks work with almost all moldings.
More On Corners And Copes
Outside corners The joint at an outside corner is formed by two simple miter cuts, but making them fit takes several steps. Don’t rush the processoutside crown molding corners are usually prominent, and so are mistakes. If the crown molding will have a varnish finish, select two pieces with similar grain patterns.
Double copes If your room doesn’t have any outside crown molding corners or require scarf joints, you’ll finish the job with a piece that’s coped on both ends. This isn’t as tough as you might think. The key is to start with a piece that’s mitered to the right length. Miter both ends and hold the piece in place to check the fit. Then cope the ends as usual.
Scarf joints On a wall that’s too long for a single piece of molding, you’ll have to ‘scarf’ pieces together. The angled cuts of a scarf joint are less visible than square cuts. If you plan on a varnish finish, select pieces that have similar color and grain patterns. Cut and install the longer piece first so the shorter piece can overlap it at the joint. Glue the joint.
Odd-angle corners Coped joints only work in square crown molding corners. If you have nonsquare inside cornerssuch as 45-degree corners in a window bayyou have to miter them. Treat odd angle outside corners just like square outside corners.
You May Like: Mold On Bathroom Ceiling
Where We Went Wrong
While we technically were correct in our method of hanging the picture frame boxes, we made a few mistakes Ill never make again.
I realized our first mistake as soon as I started painting.
Lets just say that my first instinct to paint the walls before hanging the picture frame moulding was correct.
Any time the moulding is more than 1/4-inch thick, always, always, always paint the wall first!
Otherwise, you need to cut in with a brush around every. single. piece. of. moulding.
Which wouldnt have been as bad if I didnt need three coats of paint to completely cover up that blue
I soon noticed another mistake we made in planning the spacing of the boxes.
You see, we have crown and neck moulding throughout the lower level of our house.
The neck moulding begins four inches below the crown, so I decided we should use the same spacing for all the boxes.
The top edge is four inches below the ceiling.
Theres four inches from the wall to the edge.
The space between the boxes?
Wanna guess the distance from the baseboard to the bottom box?
If you guessed four inches, you get a gold star!
Guess how much space you need for our mini paint roller to fit between the trim
That would be four and a half inches.
Which means I had to use a brush to paint all the wall spaces on the outside edges of the boxes.
Okay, so thats not a huge mistake, but if wed thought to check the spacing with the paint roller the painting wouldve been so much faster!
Tips For Installing Crown Molding
- One alternative to miter cutting crown molding is coping. Because crown molding swells and contracts with the seasons, coped joints do not open up as much as mitered joints do.
- If you have an entire house of crown molding ahead of you, purchase a crown molding support: a brace that firmly holds the trim up against the ceiling.
- Purchase the longest possible crown molding, as this will help you span entire walls without patching together two pieces with scarf joints.
You May Like: Can Black Mold Cause Lung Cancer
Make A Marking Gauge For The Crown
- Measure the run and drop of the crown molding.
- Nail two blocks together to make a marking gauge that duplicates the run and drop.
- Place guidelines at all corners and every 2 feet along walls.
- Use the marks to position the crown molding.
- Measure accurately using a two-step technique.
- First measure from a corner and make a mark.
- Then measure from the other corner to the mark and add the two measurements.
Modern Symmetrical Picture Railing
Picture railing is not just for antique-style groupings arrangements on picture rail molding can have a modern quality. Picture groupings look more modern when frames hang from wires, as opposed to twisted cord, ribbons or chains. The sense of sleek modernity increases when the picture railing is installed lower on the wall, rather than just beneath crown molding. A row of plain frames in black has a spartan, minimalist look, especially when hung symmetrically in an unexpected location, such as a bathroom. Simple chrome hooks curve over the picture railing, coordinating with streamlined fixtures in polished chrome.
Read Also: Black Mold Ceiling Bathroom
Direct Connection To The Ceiling
If for some reason your walls are altogether unconducive for hanging artwork, advises that you can drive hooks directly into the ceiling, and then utilize rope, leather, or chains to hang artworks. This could be accomplished along a ceiling beam utilizing ceiling screws as well. We recommend using care to ensure your artwork is secure, especially if hanging a heavy picture or other substantial pieces.
Free Falling by UGallery artist Jill Morton
If youre exploring new and interesting ways to display your artworks, we hope these suggestions have been useful. If youre in the market for additional original pieces, you can shop new art weekly on UGallerys website.
Making A Frame From Crown Molding
Making your own frames is surprisingly difficult. These frames are for more decoration than entirely structurally sound . But they can be used to gaudy up any space and make you realize how hard it is to get perfect 45° cuts! But fear not. It can be done, and when it can’t, thats what glue and wood filler is for.
when buying lengths
You May Like: How To Clean Black Mold In Basement
Nail The Coped Pieces Up To The Other Two Walls
Admire how fantastically they fit together. Dont forget to do this. Because these two pieces were cut too long for the wall, they bow out in the middle when you nail up the ends, see that? But when you nail the center, it will all magically lay flat, and the corners will squeeze together to give you a tight fit you can be proud of.
How Far Down Should A Picture Rail Be
Picture rail: Pictures rails are usually positioned between 12 and 20 inches below the ceiling.
Is chair rail still in style? Chair rails are still used today to create a more formal and traditional design. If thats the look your sister wants, chair rails would be a good choice.
What is a picture rail for?
A picture rail is not just a decorative moulding, it has a very specific purpose and, just as the name suggests, it is used to hang pictures from. It is a great alternative to drilling holes in the wall and it makes moving pictures very simple. 1820, the pictures were hung with single cords from studs in the frieze.
How do I secure my TV without a wall mount? You can also use earthquake straps to secure your TV to the wall, but if your flat screen isnt near a wall, you can secure your TV to the actual stand using anti-top straps. Just be sure that your stand is heavy enough not to come toppling over with the TV.
Recommended Reading: How To Get Rid Of Bathroom Ceiling Mold
How To Hang Curtain Rods On Windows With Decorative Molding
This post may contain affiliate links. Read our full disclosure here.
Do you like that super long title? lets say it together How to hang curtain rods on windows with decorative molding! Well, thats what I goggled when I was searching for ideas on how to hang curtain on windows with decorative molding.
You know what I found. ZIP Nothing. NADA
Not one idea that would help me in my decision making process.
One picture kept coming up and its beautiful! I just absolutely love Thistlewood Farm. I mean who wouldnt?
Kari Annes dining room looks like it is out of the pages of a magazine.
Although her molding on her windows is similar to mine. Its not exactly the same. My molding is way far away from the ceiling and the molding sticks out from the wall at least 4 inches. Theres almost like a shelf type quality to it. Take a look These are all of the moldings in my living room. I think in this room I will hang the curtain rods just like Kari Anne did, very close to the ceiling. Each curtain can drape between the windows.
But the kitchen is a little different.
See the ceiling is way far up there and then it angels. I would have to have like 20 ft drapes and then they would still awkwardly stick our over the molding. What to do?
I decided to purchase Martha Stewarts curtain rod pieces in white. I figured this would really work with the molding. Any dark rod would really stand out. Thats not what I wanted. Heres a list of what I purchased to get this look.